NTFS-3G could not mount – Fix

0
3459

NTFS-3G could not mount” becomes a nightmare error since the number of mac users using NTFS-3G, the only free NTFS driver, increases steadily. Look at the following article to see the causes and solutions to fix.

NTFS-3G cound not mount error

Recognize the error

Your circumstance is probably different. However, the error notification commonly begins with “NTFS-3G could not mount / dev / disk1s1 at /Volumes/…” after your NTFS driver plugged in.

The causes

Technically, this happens due to your current NTFS-3G does not support the NTFS versions associated with the driver. In other-words, you either did not install the latest NTFS-3G or installed the combination of Fuse, NTFS-3G and Fuse-wait in a right way.

Solutions to Fix NTFS-3G could not mount error

We would recommend uninstall the current NTFS-3G then reinstall the latest version in a right way.

After above solutions, that the problem remains the same is normal due to the very low compatibility of this application since NTFS-3G is a free open-source and contributed by hundreds of Linux distributions such as Fedora, Mandriva, openSUSE and Ubuntu.

So, the best solution is switching to a professional NTFS driver for mac such as Paragon NTFS 14, the best professional NTFS driver for Mac OS X.

Hot DealVery Rare Coupon: Just right now, you are able to go to Paragon NTFS 14 Discount page (Coupon applied) to gain 25% OFF on purchase from Paragon-Software store.

LEAVE A REPLY